Paul's '28 A Part I

     I went with Paul to check out this 28' Model A we found on CL. Like all great deals it was in the middle of fucking nowhere. When we rolled up it was obvious were weren't coming home without it. Super clean, straight and on a rolling chassis. Booyah! After the typical bullshitting session, bills were exchanged and we was outta there!
     He had the body and panels media blasted and he laid down some oxide primer. Meanwhile I finished up the chassis. It was fabricated from prints from these guys: Model A Prints. They seem pretty well thought out and from the pictures on their page the design has been proven. The only thing I'd change is the fitment between the tapered rails and the square rear section. I would have liked to have seen the front rails parallel and attach to a drive shaft loop/crossmember but hey, so far so good! Check it out!